Feeding Hdmi Cable Through Conduit

Supra hdmi features.

Feeding hdmi cable through conduit.

As you can see despite the sharply bent pipe the cable got through effortlessly. Fasten the braid to the pulling tool with a knot. The fish tape may get stuck on the second 90o turn or it may become caught on the previously installed cables. Picture showing how much space there is left in a 20mm pipe.

Connect the new wires plus two wires. If there is already another wire or cable inside the conduit then it is often simpler to disconnect it and use it as the pull string. Lubricating the wires. Pass the end of the wire or cable through the ring that you make in the wire.

Nylon braid is used as an aid to pull the cable through the conduit. Pulling wires can be difficult enough through straight runs of conduit but throwing a few bends and turns in the run increases friction making pulling much more difficult that s when you use a lubricant. Assembled cable and connector ready for use. Use tape to fix the end like you pull wire.

The first extra wire is to replace the wire being used as a pull string and the second is to be left in the conduit as a pull string for possible later use. Make a loop small enough that it will easily fit into the conduit then secure the loop by wrapping the free end to the wire strand with tape. A ring of the same size as a drawing wire is made in the feed cable. Method 3 pull the pull wire through the conduit.

Place your wire box so that it is free to leave the box and freely enter the conduit. Feed the end of the wire or cable through the loop you made in the pull wire. Wire pulling compound is a non conductive lubricant in either a gel or a slimy soapy form that makes both the conduit and wires slick by coating the wiring allowing.