Fibaro Temperature Sensor Not Working

In software version 4 4 and below the temperature of the internal sensor head of the fg bh t 001 thermostat is not reported to the control unit.

Fibaro temperature sensor not working.

The sensor s body and a magnet separate a radio signal is sent. I have tried to change reporting interval to 5 min and report hysteris to 1 degree but nothing happens. Fibaro motion sensor cannot be pointed at any source of heat e g. Do not cover the temperature sensor with anything.

I combined the excellence code from cyrilpeponnet the smartthings code for the sensors and come out with this version. If all the steps above fail you can ask fibaro support for help. Fibaro smoke sensor not reporting temp. The fibaro door window sensor is a wireless battery powered z wave compatible reed sensor.

Sensor is now reset. Do not place the sensor where it can be touched by people and animals or other objects that may heat or cool it and distort results. Sensor can be mounted using the included screw or the sticker. Each time its two parts i e.

So far i only tested on the following parameters but it should work with the rest. However the smoke sensors do not report temperature like they should. It is not recommended to install the motion sensor in places prone to drafts and rooms with rapid fluctuations in air temperature. The accuracy of the temperature sensor is 0 5 c.

In addition the fibaro door window sensor supports one ds18b20 temperature sensor and has one potential free input. Would this mode be possibly supported mike maxwell so that. Back to course why cannot my fibaro motion sensor be included to my z wave controller. Only the value of the external sensor is reported.

Radiators fireplaces cookers etc or at any source of light direct sunlight lamps. This version only tested on v3 2 of fibaro motion sensor it may not work on other version. A opening the device casing b holding down the b button until you see the yellow. Do not place the temperature sensor in the places where drafts are present.

It s not unnatural for somebody to think it s not working immediately and therefor check the battery inadvertently resetting the sensor. This thread suggests that i should run a simulator to get the configuration downloaded correctly to the device. It should be kept in mind that the room temperature is not evenly distributed. Step 6 is the tricky bit as it could take a couple of minutes for the sensor to stabilize and start reporting back on the z wave network.

Fibaro motion sensor is included to another z wave controller fibaro motion sensor needs to be removed using z wave controller or reset by.